What stock do you need as a service centre?
Filters O’rings Main PCB Sensor PCB Pneumatics kit Pump maintenance [...]
What equipment do you need as a service centre?
100ppm isobutylene 1,000ppm isobutylene Mass flow meter 0-300 cc/min Screwdrivers [...]
What steps are in a factory calibration?
Zero flow reading – The flow with the pump turned [...]
Why would you see a gas selection error?
You will see a gas selection error when you select [...]
What should you do if there is a H&S error?
The error occurs when a gas is selected which does [...]
What is the cause of a memory fault?
This error occurs when the instrument memory is full. To [...]
What is the cause of a lamp fault?
Contamination Damage to the lamp Lamp not frequently in use [...]
What should you look for if you see a battery fault?
Charge the device Replace the battery with a known working [...]
What is the cause of a pump fault?
The flow has gone below 50ml/min. This can be caused [...]
What are the first things you should do if you notice unstable readings?
Set the instrument back to factory calibration Check for damage [...]
